|
Description |
Price |
|
|
Item: 8-028
It includes one of my sterling water castings that has been inlaid into a base sheet of copper. Then entire piece was then hammered and formed. If you look closely you can see that different hammers were used on the copper and the silver. It includes two simple sterling rings for the bail.The pendant is about 2" tall and 1-3/4" wide and it has been coated in laquer to resist tarnishing.An 18" snake chain with lobster clasp is included.
|
$45 |
|
|
Item: 8-020
This pendant features a couple of my sterling water castings along with a piece of sterling wire and a couple of other small pieces of sterling all inlaid into a base of copper. This design is then framed with square sterling wire. I extended the frame a little to add just a bit more interest to the piece. A commercial bail (4mm) seemed like it worked best with this item and will fit most chains, wires, and many Omegas. This has been given two coats of lacquer to prevent tarnishing. The pendant is a little more that 2" wide and 1" tall (not counting the bail) and an 18" snake chain with lobster clasp is included.    |
$79 |
|
|
Item: 7-075
This pendant features both a nice needle cast and a water casting inlayed into copper along with a circle of silver. The copper has been roll printed to add texture and the entire piece framed in silver. I incoporated a more complex tube bail system into this piece. 2" across and 1-1/2" tall. 18" sterling snake chain included.
|
$79 |
|
|
Item: 8-056
This smaller water casting is approximatel 3/4" tall and incorporates two faceted gemstones; a green peridot and a pinkish-red rhodolite garnet. Includes an 18" sterling snake chain with lobster clasp.
|
$39 |
|
|
Item: 8-036
This pendant features a very nice tiger's eye with a needle casting extended down. This is a little over 2" tall including the bail. Includes an 18" sterling snake chain with lobster clasp.
|
$85 |
|
|
Item: 8-003
This inlay pendant uses two needle castings and a couple of other small pieces of 14kt. yellow gold inlaid into sterling silver. It features a simple ring for the bail. The surface is lightly textured. The pendant is just over 1" tall excluding the ring. Includes an 18" sterling snake chain with lobster clasp.
|
$59
|
|
|
Item: 8-023
This is a sterling casting created by freehand carving the cuttlefish mold. The mold was dusted to allow the grain to show and a highly polished spine was added along one edge. To top it off it features a 2.2 ct concave cut blue topaz. Just over 2" tall and includes the nice 18" sterling chain with lobster clasp.
   |
SOLD | |
|
Item: 8-015
This is a sterling cross. The cross itself is approximately 1-3/8" tall and 1-1/8" wide. Total height including the hand-fabricated bail is almost 1-3/4". 18" sterling chain included.
   |
$49 |
|
|
Item: 9-001
Sterling cross with a polished center circle and handcrafted bail. The cross is 1-1/2" tall and 1" wide; total height of 1-7/8" including the bail. Includes an 18" sterling chain.
    |
$54 |
SOLD |
|
Sterling needle casting with a 2.59 ct. green tourmaline. Approximately 1-1/2" tall including the bail. Includes a nice 18" sterling chain.
    |
$69 |
|
